User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Appendix A Specifications
E3/DS3/STS-1 specifications
112 T-BERD/MTS 5800 Getting Started Manual
E3/DS3/STS-1 specifications
Refer to these tables for specifications for the E3/DS3/STS-1
connectors:
– Table 19 on page 112 through Table 20 on page 113 list
specifications when running E3 applications.
– Table 22 on page 114 through Table 24 on page 116 list
specifications when running DS3 applications.
– Table 25 on page 116 through Table 27 on page 118 list
specifications when running STS-1 applications.
Receiver
(E3 circuits)
Table 19 lists specifications for the receiver when running
applications for E3 circuits.
Clock Source
(Timing)
– Internal reference clock with accuracy ±1.5 ppm, ±1 ppm
per year aging
– Recovered from Rx1
– External from BITS, SETS, or CLOCK
Frequency offset ±100 ppm in 1 ppm steps
Pulse shape Complies with ITU-T G.703 (11/01)
Table 18 E1 RJ-48 transmitter specifications (Continued)
Parameter Specification
Table 19 E3 receiver specifications
Parameter Specification
Connector One BNC (RX1)
Bit rate 34.368 Mbps
Impedance Nominal 75 Ω at 17 MHz, unbalanced