User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Appendix A Specifications
E3/DS3/STS-1 specifications
T-BERD/MTS 5800 Getting Started Manual
113
Transmitter
(E3 circuits)
Table 20 lists specifications for the transmitter when running
applications for E3 circuits.
Input Range Term: 0 to 12 dBnom due to cable loss at 17 MHz, from a
nominal signal
PMP: -20 dB due to resistive loss in addition to 0 to 12 dB due
to cable loss at 17 MHz, from a nominal signal
Table 19 E3 receiver specifications (Continued)
Parameter Specification
Table 20 E3 transmitter specifications
Parameter Specification
Connector One BNC (TX/RX2); used as transmitter only
Bit rate 34.368 Mbps
Line coding HDB3
Clock Source
(Timing)
– Internal reference clock with accuracy ±1.5 ppm, ±1 ppm
per year aging
– Recovered from E3 Rx
– External from BITS, SETS, or CLOCK
Frequency offset ±100 ppm, in 1 ppm steps
Pulse Nominal 1.0 Vp Complies with ITU-T G.703 (11/01)
Impedance Nominal 75 Ω