User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Appendix A Specifications
SFP specifications
122 T-BERD/MTS 5800 Getting Started Manual
SFP specifications
The interfaces of the SFP comply with INF-8074i, Rev 1.0
published on May 12, 2001. Performance is only guaranteed
when using JDSU Recommended Optics.
Supported
optical rates
Table 34 provides the optical SONET, SDH, and Ethernet
rates supported by the SFP.
XFP specifications
The interface of the XFP complies with INF-8077i, Rev 4.5
published on August 31, 2005. Performance is only guaran-
teed when using JDSU Recommended Optics.
The XFP supports the 10 Gigabit optical interfaces listed in
Table 35.
Table 34 SONET, SDH, and Ethernet rates
Rate SONET SDH Ethernet
4 Gbps N/A N/A N/A
2.5 Gbps OC-48 STM-16 N/A
2 Gbps N/A N/A N/A
1 Gbps N/A N/A 1 GigE
622 Mbps OC-12 STM-4 N/A
155 Mbps OC-3 STM-1 N/A
100 Mbps N/A N/A 100M
Table 35 SONET, SDH, and Ethernet rates
Rate SONET SDH Ethernet
10 Gbps OC-192 STM-64 10GigE