User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
T-BERD/MTS 5800 Getting Started Manual 135
Glossary
Symbols/Numerics
10G — Used on the connector
panel to represent
10 Gigabit Ethernet.
10GE — Used on the connector
panel to represent
10 Gigabit Ethernet.
10GigE — Used throughout this
manual to represent
10 Gigabit Ethernet.
802.11b — IEEE standard for
wireless LANs. You can estab-
lish wireless LAN connections to
the T-BERD ⁄ MTS 5800 using
an 802.11 adapter.
A
AC — Alternating Current. An
AC power adapter is supplied
with the T-BERD ⁄ MTS 5800.
B
BER — Bit Error Rate.
BERT — Bit error rate test. A
known pattern of bits is trans-
mitted, and errors received are
counted to figure the BER. The
Bit Error Rate test is used to
measure transmission quality.
D
DHCP — Dynamic Host Config-
uration Protocol. A communica-
tions protocol that assigns IP
addresses dynamically as
needed. The test instrument
supports static IP address
assignment.