User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
About this Manual
Getting Started Manual
xvi T-BERD/MTS 5800 Getting Started Manual
– SFP — Small form-factor pluggable module. Used on the
connector panel and throughout this manual to represent
pluggable optical modules.
– XFP — 10 Gigabit small form-factor pluggable optical
transceiver. A variety of optional XFPs are available for
testing 10 Gigabit fibre circuits.
Getting Started Manual
This is the getting started manual for the T-BERD ⁄ MTS 5800
Handheld Network Test Family. It provides basic instructions
for setting up the T-BERD ⁄ MTS 5800, instrument specifica-
tions, and contact information for JDSU’s Technical Assis-
tance Center (TAC). Read this manual carefully before
connecting your instrument to the circuit you are testing.
Figure 1 SFP transceiver
Figure 2 XFP transceiver