User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Chapter 1 Introduction
Configurations
4 T-BERD/MTS 5800 Getting Started Manual
– Optical power measurements — Ability to measure optical
power.
– Automated RFC 2544 — In addition to the standard tests,
expert tests are now available which allow you to specify
and review test settings quickly and efficiently.
– HTML viewer — An HTML viewer is available which
allows you to easily view and navigate through HTML files
on your instrument.
– Cable testing — Ability to examine the state of the cables
used to transmit 10/100/1000 electrical Ethernet signals
before you begin testing.
– Ethernet and Internet Protocol service verification —
Ability to verify proper installation and maintenance of
carrier-grade Ethernet and Internet Protocol services.
– TCP/UDP, FTP, and HTTP protocol support — The ability
to transmit and analyze traffic carried using the TCP/UDP,
FTP, and HTTP protocols.
– VLAN, Q-in-Q, VPLS, and MPLS encapsulation support
— The ability to transmit and analyze VLAN, Q-in-Q,
VPLS, and MPLS encapsulated Ethernet traffic.
For a comprehensive list of features and capabilities for each
technology supported, refer to the Testing Manual that
shipped with your instrument.
Configurations
The T-BERD ⁄ MTS 5800 Handheld Network Test Family is
factory-configured to meet your testing requirements. When
you place an order for a T-BERD ⁄ MTS 5800, a customer
service or sales representative will help you determine the
right configuration for your needs.