User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Chapter 1 Introduction
JDSU recommended SFPs and XFPs
T-BERD/MTS 5800 Getting Started Manual
11
c Gently pull the cable connector from the transceiver.
d Insert a dust plug into the open end of the transceiver.
2 Open the bail-clasp latch (as illustrated in Figure 3), and
grasp the latch and pull gently upwards to remove the
transceiver from the cage.
The transceiver is removed. Be certain to store it in an anti-
static bag.
JDSU recommended SFPs and XFPs
To ensure proper operation of your instrument during testing,
we strongly recommend purchasing the required transceivers
from JDSU. These transceivers have been tested to verify that
they will perform reliably with our test instruments.
A list of recommended transceivers can be found by select-
ing Recommended Optics from the Help menu. Or you can
obtain the list by contacting JDSU Customer Care, or con-
tacting JDSU via the company web site, www.jdsu.com.
Figure 3 SFP transceiver with open bail-clasp latch