User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Chapter 2 Getting Started
Exploring the T-BERD ⁄ MTS 5800
16 T-BERD/MTS 5800 Getting Started Manual
SFP and XFP
connectors
One XFP and two SFP connectors allow you to connect the
T-BERD ⁄ MTS 5800 to a SONET, SDH, 1 Gigabit Ethernet,
10GigE, 100 FX, or 100M Ethernet circuit to transmit and then
analyze traffic.
E3/DS3/STS-1/
E4/STM1(e)
connectors
One Tx/Rx pair or two receivers allow you to connect the
T-BERD ⁄ MTS 5800 to an E3, DS3, STS-1, E4, or STM-1e
circuit to transmit and analyze traffic.
10/100/1000M
connectors
Up to two 10/100/1000M connectors allow you to connect the
T-BERD ⁄ MTS 5800 to an electrical Ethernet circuit to
transmit and analyze traffic.
E1 connectors
Two unbalanced 75 Ω BNC receivers, and one unbalanced
75 Ω BNC transmitter allow you to connect the instrument to
an E1 (2M) circuit to transmit and analyze traffic. The
Rx 2 receiver can be used as the input for a SETS signal or
an E1 reference clock.
Figure 5 Connector panel, top of T-BERD/MTS 5812P