User's Manual

Chapter 2 Getting Started
Setting up the instrument
T-BERD/MTS 5800 Getting Started Manual
29
Setting up the
display
Setting up the display includes setting the screen brightness
and setting up the screen saver.
Adjusting screen
brightness
The following procedure describes how to adjust the screen
brightness.
To adjust the screen brightness
1 Select the SYSTEM icon.
2 Select Display.
3 Change the brightness level by moving the slider left or
right.
Setting up the
screen saver
If you are operating the instrument using the battery, you
should set up the screen saver to switch off the screen auto-
matically after the unit has not been used for a specific interval
of time.
To set up the screen saver
1 Select the SYSTEM icon, and then select Display.
2 To enable the screen saver, click the check box next to
Enable automatic screen saver.
3 To change the message displayed as a screen saver,
click in the Message field, and then enter the message.
4 To specify the time to wait until the screen saver begins,
do the following:
a Click on the drop down next to the Delay field, and
then specify the time unit, for example, seconds,
minutes or hours.
NOTE:
The Display menu also allows calibration of the touch-
screen. See “Calibrating the touchscreen” on page 93.