User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Chapter 2 Getting Started
Setting up the instrument
30 T-BERD/MTS 5800 Getting Started Manual
b Click in the Delay field. A keyboard appears. Enter the
amount of time, and then click OK. For example, if you
selected minutes in the previous step, enter the
number of minutes of delay.
5 Click the check box next to Screen saver password if
you wish to enable a screen saver password (a password
is required to close the screen saver and resume using
the instrument). Make a note of the password and put it
somewhere safe.
The screen saver is setup.
Customizing
the user
interface look
and feel
You can set up the T-BERD ⁄ MTS 5800 to emulate the FST-
2000 TestPad user interface (TestPad mode), or the ANT
platform user interface (ANT mode). This primarily impacts
the LED result format on the Main screen.
TestPad mode
If you specify TestPad mode for the LED display, the inside
green LEDs illuminate sequentially as key events occur, such
as signal detection, frame synchronization, and pattern
synchronization. The Status LED illuminates green if all
summary results are OK. If the test stops, the Status LED is
locked until you start or restart the test.