User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Chapter 2 Getting Started
Preparing for optical testing
T-BERD/MTS 5800 Getting Started Manual
35
2 To specify tuning, do the following:
a Press the Results application button to return to the
Result screen
b Use the Laser action buttons to specify the Tuning
Mode: Wavelength or Channel.
c If you selected Wavelength, click on the wavelength
field, and use the keypad to enter the wavelength.
If you selected Channel, click on the channel field, and
use the keypad to enter the channel.
Figure 18 Tuning the XFP
NOTE:
You can also specify the tuning mode and wavelength/
channel in the Setup menu on the Signal tab.