User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Chapter 3 System Tools
Viewing USB storage devices
40 T-BERD/MTS 5800 Getting Started Manual
9 To rename a file or folder, do the following:
a Click on the desired file or folder.
b Click Rename.
c Click in the name field.
A keypad appears.
d Enter the name, and then click OK.
The new file or folder name appears in the list.
Viewing USB storage devices
The USB menu allows you to view any USB storage devices
connected to the T-BERD ⁄ MTS 5800.
To view USB devices
1 Select the SYSTEM icon.
2 Select USB.
Any USB storage device connected to and recognized by
the T-BERD ⁄ MTS 5800 is listed.
NOTE:
When USB storage is found, this menu display shows the
amount of storage. Please note that 122 MB of storage
actually indicates 128 MB of space. This is due to the math
of dividing the available bytes by (1024 x 1024).