User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Chapter 3 System Tools
Specifying network settings
42 T-BERD/MTS 5800 Getting Started Manual
4 If you specified Static IP mode, do the following.
a Select IP address, then enter the IP address.
b Select Net Mask, then enter the net mask address.
c Select Gateway, then enter the gateway address.
d Select DNS, then enter the address of the DNS server.
5 Select Enable wireless adapter.
In order to access wireless networks, you must have the
JDSU USB Wifi Dongle plugged into the instrument. The
order number for this is 21139796.
The T-BERD ⁄ MTS 5800 searches for nearby networks.
Table 2 explains each of the icons that may appear to the
right of the network name.
6 Select a network to connect to.
7 If you selected a secure network, the keyboard appears.
Enter the key code, and then click OK.
The network settings are specified.
Table 2 WiFi icons
Icon Indicates
Secure network. Access requires entry of a WEP/
WPA key.
An encrypted network that the T-BERD ⁄ MTS 5800
doesn’t support.