User's Manual

Chapter 3 System Tools
Accessing the T-BERD ⁄ MTS 5800 remotely
T-BERD/MTS 5800 Getting Started Manual
43
Accessing the T-BERD ⁄ MTS 5800 remotely
The Remote Access features allows you to access the
T-BERD ⁄ MTS 5800 user interface from a PC or laptop
computer through a virtual network connection (VNC),
connecting over an Ethernet interface.
To use this feature, you must have either a browser that
supports VNC, or must have a third-party VNC viewer. In addi-
tion, the T-BERD ⁄ MTS 5800 must be connected to the same
network as the PC or laptop, and you must know the IP
address of the T-BERD ⁄ MTS 5800.
To access the T-BERD ⁄ MTS 5800 remotely
1 Using an Ethernet cable, connect the
T-BERD ⁄ MTS 5800 to same Ethernet LAN as the PC or
laptop you will use for the VNC.
2 Turn the Remote Operation feature On by doing the
following:
a Select the SYSTEM icon, and then select Remote.
b Check the box next to Enable VNC access.
3 If you wish to limit the number of connections to the instru-
ment, do the following:
a Click the box for Password protect.
When checked, the instrument will prompt for a pass-
word before allowing VNC access.
b If you wish to change the password, click in the pass-
word field, and using the on-screen keypad, enter the
password, and then click OK.
4 Configure the Network settings to match your LAN
settings (see “Specifying network settings” on page 41).
5 Establish the VNC connection.