User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Chapter 3 System Tools
Locking the test set
T-BERD/MTS 5800 Getting Started Manual
45
Locking the test set
When using your unit remotely, it is helpful to lock the screen
to prevent other users from disrupting your testing. When the
test set is locked, the screen saver is displayed.
To lock the test set
1 Select the SYSTEM icon.
2 Select Test Set Lock.
3 Select Lock test set.
4 If you wish to require a password to resume using the
instrument, select Require password and then enter the
password.
After your remote session or test is finished, it is recom-
mended that you unlock the test set for other users.
Software upgrade
The System tools allow you to upgrade the software on the
T-BERD ⁄ MTS 5800. For more information, see “Upgrading
the software” on page 95.
NOTE:
The password entered here is the same password used
with the screen saver, if enabled (a password is required to
close the screen saver and resume using the instrument).