User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Chapter 4 Basic Testing
Step 1: Selecting a test application
48 T-BERD/MTS 5800 Getting Started Manual
Step 1: Selecting a test application
The Test menu on the Main screen lists each of the available
test applications.
To select an application
1 Select Test. The Test menu appears.
2 Select the technology (for example, Ethernet), signal,
payload, and test mode for your test application.
The instrument displays a message asking you to wait
while it loads the application.
3 Wait for the Main screen to appear, and then proceed to
“Step 2: Configuring a test” on page 48.
The test application is selected.
Step 2: Configuring a test
Configuring a test involves specifying test settings and option-
ally saving the test setup.
Key settings are also available on the Main screen, on the
Quick Config tabs. Changing key settings while running a test
(for example, changing the pattern transmitted) triggers an
automatic restart of the test.
Displaying the
setup page
To display the setup page
1 Using the Test menu, select a test application (see “Step
1: Selecting a test application” on page 48).
2 Select the Setup button.