User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Chapter 4 Basic Testing
Step 5: Viewing test results
58 T-BERD/MTS 5800 Getting Started Manual
(defects). The histogram draws a bar chart of the entire test
and points out quiet periods vs. errored periods, or relative
length of errored periods.
To view an event log
1 Select the Summary group, and then select the Event Log
category.
The associated Event Log appears.
2 To scroll through the display, use the arrow keys at the
top of the pane.
The event log is displayed.
Viewing graphs
In some applications, you can observe some results graphi-
cally, such as frame loss, packet jitter, throughput, or errors.
Each graph provides a legend underneath the results to help
you interpret the graph, and controls above the results that
allow you to customize the scale and indicate whether you
want to observe the mean, minimum, or maximum value for
the results.
Figure 23 Event Log display (SONET application)