User's Manual
Table Of Contents
- T-BERD ⁄ MTS 5800 Handheld Network Test Family Getting Started Manual
- Contents
- About this Manual
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Tools
- Chapter 4 Basic Testing
- Chapter 5 Optical Tools
- Chapter 6 Maintenance and Troubleshooting
- Appendix A Specifications
- Physical specifications
- Power specifications
- Supported electrical Ethernet rates
- Clock source (Timing) specifications
- DS1 specifications
- E1 specifications
- E3/DS3/STS-1 specifications
- E4/STM-1e specifications
- SFP specifications
- XFP specifications
- Optical specifications
- Transceiver specifications
- Environmental specifications
- Appendix B Storage and Shipment
- Appendix C Customer Services
- Glossary
Chapter 4 Basic Testing
Running multiple tests
66 T-BERD/MTS 5800 Getting Started Manual
If Dual Test View is launched with only one test active, the
display will look similar to Figure 29.
Use the Add Test button to launch a second test as described
in “Running multiple tests” on page 61.
Figure 28 Dual Test view with one active tests