Instruction Manual To ensure maximum performance and safety, please follow this manual.
OWNERS MANUAL Model: DELTABOX BASS GENERATOR Congratulations on purchasing your VIBE DeltaBox bass Generator Please read this manual in order to fully understand how to get the best results from your DeltaBox Please ensure that all advice on how to look after your bass generator is followed. Thank you for buying VIBE, we hope you enjoy listening to your product as much as we enjoyed creating it.
Front panel 1. AUX input Low level input that can be connected to IPOD / MP3 player / DVD player / games console via the supplied 3.5mm stereo jackplug lead. 2. SUB level control This control sets the subwoofer level for the main input. 3. Main / AUX input switch This switch switches between main and AUX input. 4. Crossover frequency control This control is used to set the low pass crossover point for the output. The frequency can be adjusted from 40Hz to 400Hz. 5.
Jumper settings The Deltabox Bass Generator is equipped with 2 internal jumpers. These jumpers set the operation of the tone generator to either 2 second operation or constant operation for the panel button and the remote control. In the factory preset mode when either the remote control or panel button for the tone generator is pressed the chosen tone will play through the subwoofer for 2 seconds before switching off and returning to normal music.
To remote turn on from headunit To chassis ground Fuse close to battery Switched remote output for other devices RCA output (Subwoofer output recommended) To IPOD / MP3 player / DVD player / games console To RCA input of amplifier
Set up guide Main input / Aux input Set the SUB LEVEL control to the minimum setting. Set the CROSSOVER control to the desired frequency. This will vary depending on the type of subwoofer system that have. As a rough guide if you prefer deep bass set the frequency between 40Hz – 60Hz, and 80Hz – 120Hz for punchy bass. Set the volume level of the source to around 3/4 or just below the point of the speakers beginning to distort.
Troubleshooting Unit will not switch on Check that there is +12 volts present on the +12 volt and remote in terminal and that the ground terminal is connected to a good chassis ground Check the fuse on the +12 volt wire has not blown No Sound Check that the correct input (Main or AUX) is selected. If the Bass amplifier is connected to the REMOTE TURN ON OUTPUT ensure that the REMOTE TURN ON switch is set to “ON” Check that the jumpers are correctly set.
Notes
In order to protect your purchase and aid your warrantee please fill in the following form and keep it safe for your future reference: Model Number: Serial Number: Purchased From: KEEP IT SAFE Staple your receipt here: Date of Purchase: Limited Warranty All VIBE products carry a full twelve months warranty, valid from the date of the original receipt / proof of purchase. In order to validate this warranty, the warranty card should be returned to VIBE within seven days of the original purchase date.
FLATBASS™ 13 SPK Bass speaker cable There are many powerful bass amplifiers on today’s market – the ever increasing power is putting huge strains on speaker wire – VIBE present a new breed of speaker cable specially developed for BASS applications – the VIBE FLATBASS speaker cable offers SolidCores™ that can handle and sustain considerably more power than conventional speaker cable.
The CriticalLink™ range of FLAT series cabling from VIBE The VIBE CriticalLink range of cabling has been developed to achieve the critical link between source (headunit), amplifier and speakers – VIBE audio equipment is high quality, using anything less than the VIBE CriticalLink™ range of cables will severely compromise your equipment and will not allow it to perform to its maximum potential. NOTE: Your audio equipment will only ever be as good as the cables you use to connect it.
