User's Manual

MONITOR RESET
If you are unable to pair the
equipment with the steps
provided, reset the monitor.
Monitor reset: Press the
"Mode" button for 7 seconds
approx. until the rate and
compression icons flash
once.
Make sure the monitor is
switched off, then switch it on
and begin the pairing process.
BATTERY CAUTION
The batteries supplied with the BABY TYLER should be replaced when the red
light appears on the monitor indicator.
Using uncharged batteries with either the monitor or the torso will impede
proper functioning of BABY TYLER.
There are no interference implications using rechargeable batteries.
(Red lights)
KEY FEATURES & FUNCTIONS
KEY FUNCTIONS
ADDITIONAL FUNCTIONS
COMPRESSION FEEDBACK
DEPTH: 1/3 Chest DiameterRATE: 100 <> 120 bpm
GREEN
RED
RED
GREEN
STANDARD/BLIND MODE
STANDARD MODE BLIND MODE
WAIT 10 SECONDS
FOR TEST REPORT
SETTING UP
Insert batteries (9V x 2) into the torso and the monitor
(included in each
BABY TYLER pack).
Allows you to select standard or blind mode
Feedback is not visible during practice in blind mode. View the test report 10
seconds after the session has finished in both modes.
PAIRING
Switch on the monitor and press
BABY TYLER’s torso until
you hear the double beep sound and the "TORSO"
light turns green.
BABY TYLER is now
ready to use.
When switching on the monitor,
the default always activates on
standard mode.
1. Remove the chest skin.
2. Remove the face skin.
3. Move the lung below
the jaw.
4. Connect the lung to
the mouthpiece
5. Place the lung on the chest.
7. Place chest skin and
attach to the studs.
6. Fit the face skin,
checking that the nose,
mouth & upper tab are
in the correct position.
BABY TYLER
ASSEMBLY