Operation Manual

English
05
Camera and Cord Installation
Installation Steps
1.
2.
In order to keep the device functioning properly, please use the
VicoVation power cable that comes with the package at all times.
Plug the power cable into the D/C outlet then connect the USB side
with Vico-MF2 insert into the power port.
Recommend Installation Position for Wiring
Recommend Area
To achieve a clean looking installation after you have plugged the camera in
follow the cord back from the camera and tuck it in under the roof headliner.
Then run it along the “A” Pillar and tuck it behind. Finally hide the cable
under the passenger side floor mat.
1.
2.
3.
Special Notice:
It is not recommended to wiring the cables on your own if your car is
equipped with airbags in the “A” Pillar. Please seek for professional
assistance.
To avoid effecting the water proof performance on the doors, please
restore the rubber seal properly after wiring the power cable.
MF2 Power Cables are specially designed and only for MF2
dashcams.MF2 Power Cables are not compatible with other
VicoVation products.