Installation guide

10
• Connecting to the RJ-45
Connect a standard RJ-45 cable to the network port of the network camera. Generally a
cross-over cable is used for directly connection to PC, while a direct cable is used for connection
to a hub.
 Micro SD memory slot
Insert the SD memory card (customer supplied).
• Connecting the Power
Connect a 12 VDC power adaptor (customer supplied) to the camera.
• Connecting Service Monitor Port
The Service Monitor output port is located on the board of the dome camera and is used for easy
OSD setup.
▶ ID & IP assignment
To make changes in the OSD menu, the optional OSD controller can be used to set camera title
and IP address.
1. Connect the OSD Controller to the Service Monitor port of the network camera.
2. Connect Service Monitor and the Video Output port of the OSD Controller.
3. Press the SET button on the controller to access the Main Menu.
4. Change camera ID and IP address as needed. Additionally, the Name (or title) of the camera
can be changed. Use the ↑↓←→ buttons on the controller to change the parameters.
5. Select SAVE or CANCEL to exit the Main Menu.
The Video Output can also be used for easy zoom and focus control when adjusting the lens.
Video Output is restricted to 704x480 (576) resolution.
Note: The optional V920D-OSD OSD Controller can be purchased separately.