Installation guide

33
To create a motion or mask window, follow steps:
1. Click the right button of mouse to see the mouse menu.
2. Select New Motion (or Mask) Window in the mouse menu.
3. Click and drag mouse to designate a motion area.
• Motion Detection Setting
The behavior for each window is defined by adjusting the Threshold and Sensitivity, as described
below. The combination of these parameters defines whether motion has occurred; motion
detection frequency is increased with a high sensitivity and a low threshold.
A motion index is a set of parameters describing Window Name, Type, Threshold, Sensitivity, and
Dwell Time. Window Type is Include at the Motion and Exclude at the Mask window.
- Threshold: Sets up the threshold for the motion detection. Threshold judges the amount of
change in the area. Select from 1-100; a lower number increases frequency of alarms.
- Sensitivity: Sets up the sensitivity for the motion detection. Sensitivity measures the
level of motion in each motion area. Select from 1-100, 1 being the least sensitive to
alarm condition.
- Dwell Time: Set the hold time an event lasts from the point of detection of a motion
(hold time).
You can also modify or delete a motion index. It can be deleted using the table and modified by
selecting it and changing parameters in the table. Change the size of the mask by dragging the
borders or corners of the mask or click in the center of the mask to change the location; select
delete button to completely remove the mask. When the settings are complete, click Save, or
click Reset to revert to previously saved settings.
To exclude parts of the Include window, select the New Mask at the mouse menu and position
the Mask window as required.