Installation guide

35
2) Event-Out
 SMTP (E-Mail)
The network camera can be configured to send event and error email messages via SMTP (Simple
Mail Transfer Protocol).
Select “Enable SMTP” to activate the SMTP operation.
- Sender: Enter the email address to be used as the sender for all messages sent by the
network camera.
- Interval: Represents the frequency of the email notification when an event occurs.
- Aggregate events: Shows the maximum number of emails sent within each interval.
Check the box to "Use mail server" if required.
- Mail Server/Port: Enter the host names (or IP addresses) and port numbers for
your mail server in the fields provided to enable the sending of notifications and
image email messages from the camera to predefined addresses via SMTP.
If your mail server requires authentication, check the box for "Enable use (SMTP) authentication"
to log in to this server and enter the necessary information.
- User Name/Password: Enter the User Name and Password as provided by your
network administrator or ISP (Internet Service Provider).
To ensure that the login procedure is performed as securely as possible when using
SMTP authentication, you must define the weakest authentication method allowed.