Installation guide

53
 RTP
Create a setting for sending and receiving audio or video on a real-time basis. These settings are the
IP address, port number, and Time-To-Live value (TTL) to use for the media stream(s) in multicast
H.264 format. Only certain IP addresses and port numbers should be used for multicast streams.
• Port Range
- Start/End port: Enter a value between 30000 and 39920.
• Multicast
This function is for sending video to multicast group.
- Enable Multicast: Check the checkbox to enable multicast operation.
- Multicast destination IP: Enter an IP between 224.0.0.0 and 239.255.255.255.
- RTP port: Enter a value between 1024 and 65530.
RTP TTL: Enter a value between 1 and 255. If a network status is smooth, enter a lower
value. On the other hand, if a network status is poor, enter a higher value. When there are
many network cameras or users, a higher value may cause a heavy load to the network.
Consult with a network manager for detailed information.
- Always enable multicast: Check the box to start multicast streaming without opening an
RTSP session.
When the settings are complete, click Save, or click Reset to revert to previously saved settings.