User`s manual

RAIDWatch User’s Manual
12.3 LED Representations
As described earlier (see Section 12.1), the Enclosure View is a direct
representation of the physical devices. Almost every major component has
its status-indicating LEDs. When a component fails (or some other event
occurs), the related LEDs will flash or change the display color. The
physical status of the LEDs will be reflected by the LEDs shown in the
Enclosure View window. That is, if an LED on the physical device changes
its display color, then the display color of the corresponding LED in the
Enclosure View window will also change.
Figure 12-4: Enclosure Tabbed Panel and Component LED Display
The definition for each LED has been completely described in the
Installation and Hardware Reference Manual that came with your RAID
controller/subsystem. Please refer to the manual to determine what the
different LEDs represent.
12.3.1 Service LED (on Models that Come with an
LED panel)
Service LED for RAID/JBOD subsystems:
The service LED can be enabled by RAIDWatch management software
from a remote site to identify which subsystem is being serviced. The
corresponding subsystem LED will also be lighted in RAIDWatch GUI.
Pressing the service button on the subsystem can also enable the service
LED.
12-4 Enclosure Display