User`s manual

Chapter 13: NPC Utility Coupled with Mode Three Installation
Receiver's email: Shows a list of all the email addresses that the
NPC will send a message to. Addresses added will be listed on
the right.
Severity: Select the severity level of events to be sent to the
receiver station.
Step 5. Click
Apply or OK to complete the configuration.
13.2.3 SNMP Traps
Step 1. Click on the Notification Process Center Setting tab and SNMP
Trap
to display SNMP settings.
Figure 13-5: SNMP Traps – Sender-side Settings
Step 2. Fill in or select the following configuration fields:
Enabled: Select this check box to enable the notification.
Community: This is just a string authentication and can be seen
as a plain text password.
Step 3. Click
Apply or OK to proceed with configuration. Note that the
configuration will be saved to the reserved space on the array and
may cause a short delay.
Step 4. Click
SNMP Trap List from the tabbed panel above.
Configuring the Utility Options 13-5