Product specifications

15. Align the tabs on the camera
drive with the slots in the
housing, matching up the two
arrows on the camera drive and
the housing.
Figure 17
Installing the Safety Cords
WARNING: Cables having
excessive slack can
cause damage to the
SurveyorVFT when
installed into the
housing.
16. Push the camera drive straight
up into the housing until it snaps
into the housing. Do not use
excessive force. In the event that
it does not snap easily, remove
the SurveyorVFT and verify
proper cabling.
17. Holding the lower dome, line up
the 2 molded tabs on the lower
dome with the 2 parallel surfaces
of the housing. Push the lower
dome up and verify that it snaps
into place on both sides. See
Figure 18.
18. Tighten the 4 trim ring captive
screws to hold the lower dome in
place. Verify proper orientation of
the grommet.
19. Proceed to the Operation section
of this manual.
XX134-08-01 Rev 209 SurveyorVFT Camera Dome System 4BInstallation • 25