Product specifications

Uninstalling the SurveyorVFT
The SurveyorVFT camera drive can be easily uninstalled by simply pushing in the tabs to release the camera
drive from the housing or the enclosure. A safety cord is always available to safely hang the camera drive or
camera dome assembly while installing or uninstalling.
For an In-Ceiling Installation
Figure 25
Uninstallation
1. Gently pull down on the lower dome’s
outside edge, with two hands, until all
molded tabs snap out of place.
2. Push in the tabs to release the
camera drive from the enclosure. It
will hang from the safety cord. Refer
to Figure 25.
3. If it is necessary to completely remove
the camera drive, disconnect the
safety cord clip.
For a Pendant Installation
1. (Outdoor Pendant model only) Loosen
the 4 trim ring screws from the
outdoor lower dome.
2. Gently pull down on the lower dome’s
outside edge, until it snaps out of
place.
3. Push in the tabs on the housing until
the SurveyorVFT camera drive is
released. Refer to Figure 25.
4. Allow the SurveyorVFT to gently drop
down until it is supported by the safety
cord.
5. If it is necessary to completely remove the SurveyorVFT, disconnect the clip on the end of the safety cord
from the latch on the housing.
XX134-08-01 Rev 209 SurveyorVFT Camera Dome System 7BUninstalling the SurveyorVFT • 51