System information

MX Control Card Configuration
A-6 Vicon MX Hardware System Reference
GPIO Output Status Events
The GPIO outputs status events after the remote action has been
triggered. You can configure other devices in your system to read
these events and respond accordingly, as illustrated in the following
examples.
The example in Table A-4 shows the status events output by the GPIO
after the remote action has been triggered by a third-party treadmill
(where High=5V and Low=0V).
The example in Table A-5 shows the status events output by the GPIO
after the remote action has been triggered by a Kyowa-Dengyo Force
Plate (where High=5V and Low=0V).
Table A-4: GPIO control output status—third party treadmill
Output Status Vicon System Event
GPO 1 GPO 2 GPO 3 GPO 4
Low Low — — Idle (no capture in progress)
High Low — — Armed (prepared for capture)
LowHigh——Paused
High High — — Capturing
Table A-5: GPIO control output status—Kyowa-Dengyo Force Plates
Output Status Vicon System Event
GPO 1 GPO 2 GPO 3 GPO 4
High— ——Capturing
Low — — — Idle (no capture in progress)
—Zero
Balance
+CAL -CAL Reserved for use by Kyowa-
Dengyo Force Plates. For
details, contact your local
representative.
MXhardware_Reference.book Page 6 Thursday, September 7, 2006 11:36 AM