System information

MX Control Card Configuration
A-18 Vicon MX Hardware System Reference
4. Pass the cables through the inlet on the side of the box with the
cable grip flanges.
5. Install the signal cables into the screw terminal marked
CH1-CH64.
6. Install the braided and ground cables into any screw terminals
marked SGND (Signal Ground).
7. When complete, clamp the cables using the grip flanges.
8. Align the lid and box grooves and rims, and then replace the lid,
screws, and screw covers.
9. Plug one end of a 100-way cable, shown in Figure A-5, into the
Vicon patch panel, ensuring that it clicks firmly into place.
Figure A-5: 100-way cable
10. Plug the other end of the 100-way cable into the ADC card edge
socket on the rear panel of the MX Control, shown in Figure A-6,
ensuring that it clicks firmly into place.
Figure A-6: ADC edge socket
11. Wire the plug you created for your third-party device into the
patch panel.
MXhardware_Reference.book Page 18 Thursday, September 7, 2006 11:36 AM