System information

MX Cameras
Vicon MX Hardware System Reference 3-17
Volume Calibration
During the
Calibrate Cameras process, the strobe unit status lights
provide the following information when the
Start Wand Wave button
is pressed and when the
Stop Wand Wave button is pressed:
•Green
• Yellow
•Blue
LED continues to indicate the camera’s selection state in the Vicon
software:
Calibration Health Check
After the Calibration Health Check process, the strobe unit status
lights reflect the results:
•Green
On: During wand wave: Sufficient calibration wand data
has been collected.
After wand wave: Final calibration status of Good or
Awesome
Off: Calibration not complete.
On: After wand wave: Final calibration status of OK or
Good.
Flashing: During wand wave: Collecting calibration wand data.
The flashing frequency increases until sufficient data
has been collected.
After wand wave: Final calibration status of Dropped
or Bad.
Off: Sufficient calibration wand data has been collected.
On: Selected.
Flashing: Selected as primary.
Off: Not selected.
On: Both the
RMS Distance status and the Prop
Unassigned
status are good.
Off: Calibration Health Check is not complete, or if the
status of one or more of is good.
MXhardware_Reference.book Page 17 Thursday, September 7, 2006 11:36 AM