System information

MX Cameras
3-18 Vicon MX Hardware System Reference
• Yellow
•Blue
LED continues to indicate the camera’s selection state in the Vicon
software:
Camera Reordering
During a Reorder Cameras process, this strobe unit status light
indicates the camera selection:
•Blue
Strobe Unit Function Indicator (NIR and IR)
The strobe function indicator at the top of the ring of infrared diodes
on NIR and IR MX strobe units with through-hole LEDs provides
feedback on the status of the strobe lights. For MX+ strobe units with
surface-mount LEDs, this status information is available through the
Vicon application software.
The strobe unit function light provides the following information:
•Green
Small, visible LED indicating all infrared diode segments are
functioning normally.
•Red
Small, visible LED indicating the strobe or its drive feed from the
camera is faulty.
On: Either the
RMS Distance status is poor or the Prop
Unassigned
status is high.
Flashing: The
RMS Distance status is poor and the Prop
Unassigned
status is high.
Off: Calibration Health Check is not complete, or the
status for both is good.
On: Selected.
Flashing: Selected as primary.
Off: Not selected.
Flashing: Camera selected for reordering.
MXhardware_Reference.book Page 18 Thursday, September 7, 2006 11:36 AM