System information

MX Link
Vicon MX Hardware System Reference 6-3
• Power On: LED indicating whether or not the MX Link is on and
receiving power:
• Four numbered device sockets and corresponding green LED
status indicators (located to the left of the sockets), including:
• Link Connect: 12-pin Lemo sockets for connecting to
MX Nets.
Use this connection for systems whose number of cameras
plus alternative devices is greater than eight. Multiple MX Nets
can be connected to an MX Link. For details on MX Nets, see
Chapter 7 MX Net. For details on the MX Net—MX Link cable,
see Chapter 11 MX Cables.
• Master: LEDs indicating which of the attached devices is
providing the master synchronization signal to the system.
• On/Off Switch
Switch for turning the unit on and off.
• Power Connector
Power cable inlet. Fuses are located in a panel between this
connector and the on/off switch.
Warning
For full protection against electrical shock hazards, the unit must be
connected to a grounded electrical supply.
On: The unit is on and receiving power.
Off: The unit is turned off, or the power cord is not properly
connected.
MXhardware_Reference.book Page 3 Thursday, September 7, 2006 11:36 AM