System information

MX Net
7-4 Vicon MX Hardware System Reference
•Power On
LED indicating whether or not the unit is on and receiving power:
• Eight numbered device sockets and corresponding green LED
status indicators (located to the left of the device sockets),
including:
• Net Connect: 10-pin Lemo sockets for connecting cameras
(or alternative devices such as the MX Control). For details on
the MX Net—Camera cable, see Chapter 11 MX Cables.
• Master: LEDs indicating which (if any) of the devices attached
to the MX Net is providing the master synchronization signal
to the system:
•Enable
LEDs indicating whether or not the device is connected correctly:
• On/Off Switch
Switch for turning the unit on and off.
• Power Connector
Power cable inlet. Fuses are located in a panel between this
connector and the on/off switch.
Warning
For full protection against electrical shock hazards, the unit must be
connected to a grounded electrical supply.
On: The unit is on and receiving power.
Off: The unit is turned off, or the power cord is not properly
connected.
On: The connected device is providing the master
synchronization signal.
Off: The connected device is not providing the master
synchronization signal or is a slave device.
On: The device is correctly connected.
Flashing: The device is drawing too much current (may indicate
a short circuit).
Off: The device is not correctly connected.
MXhardware_Reference.book Page 4 Thursday, September 7, 2006 11:36 AM