System information

MX Cables
Vicon MX Hardware System Reference 11-3
the same host PC or a second computer, depending on CPU consumption and
hard disk performance.
MX Sync—MX Control Cable
A cable terminated with a 15-pin D-type plug at one end (for the
MX Sync) and splitting to terminate in 8-pin and 7-pin Lemo plugs at
the other end (for the MX Control). This cable is used to connect an
MX Sync to an MX Control.
MX Ultranet—MX Link/MX Net
A cable terminated on one end with a 10-pin RJ-45 plug and on the
other end with a 12-pin Lemo plug. This cable is used to connect an
MX Ultranet to either an MX Link or an MX Net.
MX Ultranet—MX Sync Cable
A cable terminated on both ends with 15-pin D-type plugs. This cable
is used to connect an MX Ultranet to an MX Sync.
MX Ultranet—MX Ultranet Cable
A cable terminated on both ends with 10-pin RJ-45 plugs. This cable
is used to connect a primary MX Ultranet to any secondary
MX Ultranet units included in the Vicon MX system.
Up Link/Down Link Cable
A cable terminated on both ends with 4-pin Lemo plugs when used
to connect an MX Link to another MX Link, or terminated on both ends
with a 3.5mm Stereo Jack when used to connect a primary
MX Ultranet to another primary MX Ultranet.
MXhardware_Reference.book Page 3 Thursday, September 7, 2006 11:36 AM