Installation guide

9.2 Event
Event SD Writing
You can configure the camera to store still images based on events such as Alarm In and Motion
detection.
NOTE: This function cannot be used when Installation mode is turned ON. Set the first stream to
1280x720 or 1280x720 (wide) in the Video > Codec section, and second stream to M-JPEG or
‘None’.
SD Writing
SD Writing will Enable/Disable event recording to the SD card.
When Disabled, all remaining menus will be deactivated.
Directory
The name of the sub-directory where the still images will be stored when an Event occurs.
File Prefix
You may add a file name prefix to the stored image file name.
Example: If the file prefix is ‘alm’, the still image would be saved as alm_date_time.jpg.