Product specifications

Quick Installation Guide
1. Use camera mounting frame as template to mark mounting holes on mounting surface. (Fig.1)
2. Drill holes for mounting base and a minimum 3/4 in. hole for routing wines. (Fig.1)
3. Mount camera mounting frame using appropriate hardware for mounting surface. (Fig.2)
4. Route wires through hole in wall and out through base plate. (Fig.2).
5. Terminate wires to camera board.
6. Mount front plate to base plate. (Fig.2)
7. When the camera mounting frame is secured to the surface, apply an epoxy security sealant
around the perimeter of the base plate where it meets the ceiling/wall. [Vicon recommends
DynaPoxy™ EP1200 (US) or Arbokol 1025 (UK) or equivalent for this purpose.]
When using rear panel, follow diagram below. Installation of the rear cover is required for
UL/Canadian UL compliance.
1. Use rear cover as template to mark mounting and cable access holes.
2. Drill mounting and cable access holes in mounting surface.
3. Insert cable clamp into access hole, route cables through clamp and mount cover using
appropriate hardware.
4