ZigBee Pro Module Installation Guide VT8000 Series Room Controllers Optional ZigBee Pro Module (VCM8000V5000P)
ZigBee Module Installation Guide 2 This guide shows you how to install the ZigBee Pro wireless module with a VT8000 Series Room Controller. 1. Remove security screw on bottom of Room Controller cover. 2. Open unit by pulling on bottom of Room Controller (Figure 1). 3. Carefully remove Room Controllers Motherboard from casing and turn over. 4. Locate gap in upper-right corner of Room Controllers Motherboard and locate holes to insert ZigBee Pro module to Motherboard (Figure 2). Figure-1 5.
ZigBee Module Installation Guide 3 Quick setup This short procedure is intended to let you pair a ZigBee sensor with your Room Controller. It assumes that all the back-end configuration of the stand alone Room Controller acting as coordinator or the Multi-Purpose Manager (MPM) coordinator for the ZigBee network has already been done, and it assumes that the user is familiar with the Permit Join function and the Wireless Ecosystem screen functions. PROCEDURE 1.
