Installation Guide User guide

ManualsBrandsViconics ManualsFor HomeVTR8300 Line Voltage

VTR8300 Series Installation Guide

Room Controller with Optional PIR sensor

Commercial and Hotel/Lodging HVAC Fan Coil Applications

CONTENTS

Installation 2

Location 2

Installation 2

Terminal, Identiﬁcation and Function 3

Communication wiring to VC3xxxX Relay Pack 3

BACnet

Communication Wiring (if applicable) 3

Network wiring topology 3

How to Enter Setup Screen 4

Setup Screen Display 4

Speciﬁcations 5

Drawing and Dimensions 6

Summary of content (7 pages)

PAGE 1
VTR8300 Series Installation Guide Room Controller with Optional PIR sensor Commercial and Hotel/Lodging HVAC Fan Coil Applications CONTENTS Installation Location Installation Terminal, Identification and Function Communication wiring to VC3xxxX Relay Pack BACnet® Communication Wiring (if applicable) Network wiring topology How to Enter Setup Screen Setup Screen Display Specifications Drawing and Dimensions 2 2 2 3 3 3 3 4 4 5 6
PAGE 2
Installation Guide VTR8300 Series Disclaimers • The VTR8300 series controller is only to be used in conjuction with the VC3000 line voltage switching relay pack. Together they are used as operating controls for high voltage fan coil units. • If replacing an existing Line Voltage FCU Controller, label the wires before removal of the controller. • Electronic controls are static sensitive devices. Discharge yourself properly before manipulating and installing the Terminal Equipment Controller.
PAGE 3
Installation Guide VTR8300 Series INSTALLATION • Open unit by pulling on bottom side of Terminal Equipment Controller (Figure 1). • Read FCC ID and IC label installed in cover. • Ensure wall surface is flat and clean. Location 1. Do not install installed on outside wall. 2. Do not install in areas with exposure to direct heat source. 3. Do not install in areas near air discharge grill. 4. Do not install in areas with direct sun radiation. 5.
PAGE 4
Installation Guide VTR8300 Series TERMINAL, IDENTIFICATION AND FUNCTION Terminal Identification All VTR83xxA Terminal Equipment Controller Terminal 4 Tx – Rx Communication Terminal 5 Power Hot 7.0 VDC Terminal 6 Power Common Terminal 13 BACnet + Terminal 14 BACnet - Terminal 15 BACnet REF Terminal 16 BI 1 ( Configurable ) Terminal 17 BI 2 ( Configurable ) Terminal 18 Scom Only ONE VC3xxxX Relay Pack with remote monitoring inputs can be used under a single VTR83xxA Controller.
PAGE 5
Installation Guide VTR8300 Series Home Screen Display Hospitality User Interface Shown Time System Status Date Occupancy Status Fan Status Up Arrow Increase Temperature Setpoint Indoor Temperature Actual Setpoint Down Arrow Decrease Temperature Setpoint Indoor Humidity Outdoor Temperature Help System Mode Short Network Message Fan Mode Language Selection Note: User HMI is configurable and allows display functions such as Date, Time, Humidity, Outdoor Temperature, Setpoint, and others to be ena
PAGE 6
Installation Guide VTR8300 Series How to Enter setup screen Touch and hold this point for 3 seconds to enter setup mode Note: If a configuration / installer password is activated to prevent unauthorised access to the configuration menu parameters, a password entry prompt will appear to prevent access to the device configuration components.
PAGE 7
Installation Guide VTR8300 Series Appendix A: Power outage Clock Reset Outage duration Room Controller behaviour 0 - 24 hours Clock functions are normal 24 - 36 hours Clock accuracy not guaranteed, time may need to be adjusted 36 - 72 hours Clock no longer increments and will need to be adjusted when power is restored. 72+ hours Clock functions are fully reset, and will need to be reinitialized as per a new installation. Viconics Technologies Inc. 028-0414-02 | 9245 Langelier Blvd. | St.