User Manual

FlatPAC-EN/EN MI Configuration Layout
Pg 6 Vicor 800-735-6200 Westcor Division 408-522-5280 Applications Engineering 800-927-9474 03-000050 rev A
FlatPAC-EN/EN MI Design Guide
CBJ1
Interface Conn.
M2
VI-200 Maxi
M1
VI-J00
or Mini
MBJ1
Input Conn.
MiniHAM
CBJ1
Interface Conn.
MBJ1
Input Conn.
M2
Micro
M1
Micro
M3
Micro
MiniHAM
M4
VI-J00 or Mini
CBJ1
Interface Conn.
M1
VI-J00 or Mini
MBJ1
Input Conn.
MiniHAM
M2
VI-J00 or Mini
M3
VI-J00 or Mini
Single or Dual Outputs
(Stud Connectors)
Single, Dual orTriple Outputs
(Two 18 pin Molex Connectors)
Single, Dual, Triple or Quadruple Outputs
(Two 18 pin Molex Connectors)
For a single output configuration, either M1or M2 is used
(assumes either a full brick and/or half brick is used)
(assumes only half bricks are used)
Note: The type of output connector a FlatPAC-EN has depends on which modules are used. E.g. if a two output configuration uses two half bricks (instead of a full brick and half brick) this two output configuration will have the 18 pin molex connectors, not stud connectors.
(assumes only half and/or quarter bricks are used)