Installation Manual
Wall and ceilling surfaces should be examined prior to installation, ensuring they are clean, smooth, and dry. If
you have unpainted gypsum board surfaces, these should be primed with a drywall primer (or another material
manufactured especially for the purpose), to equalize the absorption between the gypsum board face paper,
joint compound, and skin coating materials. You should then apply the paint, and allow air circulation in order to
dry the paint within the time frame specied by the paint manufacturer. Please ensure the paint is dry before
installing the acoustic panel. Make sure the room has all the necessary conditions to receive the acoustic
panels. After you apply the glue on the back of each acoustic panel, please ensure you hold the acoustic panel
against the wall the required time (mentioned above), and ensure it stays xed in place.
This method is also applicable to ceiling installations.
!
To ensure that you maximise the strength of the glue, don’t make any adjustments
to the panel after bonding.
!
Please note: For ceiling installation, it is recommend to leave some centimeters beyond the last panel to
avoid it to loose contact with the VicFix J prole. In countries where earthquakes are likely to happen,
it should be applied a blocking element such as a L prole to avoid the last panel to slide off the VicFix J
prole. Vicoustic will not take responsibility for any mistakes / limitations occurring during installations or
any damages resulting from falling panels.
EN