Product specifications

6
INSTALLING THE HOLE
SAW ONTO THE ARBOR
ASSEMBLY
1. Depending on the type of arbor assembly
included with the tool, thread or push the lock-
ing ring of the arbor assembly back as far as it
will go.
2. Thread the hole saw onto the arbor assem-
bly just enough to line up the holes in the top of
the hole saw with the drive pins on the arbor
assembly. If the pins do not line up with the
holes, back off the hole saw just enough to line
up the holes with the drive pins
3. Thread or push the locking ring of the arbor
assembly all the way down, making sure the
pins of the arbor assembly engage the holes in
the top of the hole saw. Make sure the hole saw
is flush with the arbor assembly and that the
hole saw is installed firmly onto the arbor
assembly.
TOOL SETUP AND
OPERATION
1. Ensure that the pipe is secured before
attempting to use this hole-cutting tool.
2. Locate the center of the hole to be cut on
the pipe run. Mark this center point clearly
with a punch.
3. Place the hole-cutting tool onto the pipe.
Hook the chain around the pipe and insert it
into the chain slot on the side of the tool’s base.
Leave the chain loose enough to allow base
movement.
• DO NOT plug the tool into the electrical source until
instructed.
Failure to follow this instruction could result in serious
personal injury.
NOTICE
• When selecting the hole location, take into account
the width of the product you are installing. Ensure
that it will fit and not interfere with couplings or
grooves. Additionally, allow room on the pipe to
mount the hole-cutting tool.
HCT908