User's Guide

www.hasselblad.com
23
QUICK START
CONTENTS
THE FIRST CAPTURE
Press and hold the power button (1) for one second to turn
the camera on. When the status LED (2) has turned green it is
readytomaketherstcapture.
Gently press the shutter release (half-press) to activate live
view on the screen. With the default setting, the camera is in
Aperture priority mode indicated by an “A” at the lower left
part of the display. Use the control wheel to select another
aperture if required. Aperture and shutter speed are indicat-
ed at the bottom of the live view screen (A)
Aim the camera at the subject. The rectangle in the center
of the image is the active area for Autofocus (AF). Half-press
again to focus. Keep the button at half-press and re-compose
if necessary and press the shutter release all the way to make
the capture. The image will appear on the screen within a few
seconds.
The default ISO is 100. Use the following steps and to set a
different value:
● If the display is not already activate, press any of the
rear buttons.
● Placeyourngeratthetopofthescreenandslide
down to reveal the control screen (A). You can do this
from any screen.
● Tap the ISO value in the top right area (B). Scroll
through the list of ISO values by sliding up/down and
tap the required value (C)
toconrmthenewISOvalue
Note!
From the control screen you can also change white balance by
tapping the white balance icon in the top left corner.
See more on page 46.
907X Special Edition USER GUIDE
C
D A
B
1
2