User's Guide
Table Of Contents
- 1 INTRODUCTION
- 2 Quick Start
- 3 Safety
- 4 Parts & Controls
- 5 Using the 907X
- 5.1 Touch display
- 5.2 Touch display main menu
- Main Menu
- Add shortcuts to main menu favourites
- How to add shortcuts to main menu
- How to remove shortcuts on the main menu
- How to move shortcuts on the main menu
- Control screen
- Locked exposure parameters on the control screen
- Settings on the control screen
- Self Timer settings
- Interval settings
- Interval operation
- Exposure bracketing settings
- Exposure bracketing operation
- Long exposure screen
- Fixed exposure compensation setting
- Light meter mode
- 5.3 Memory cards
- 5.4 Live view indications
- 5.5 Focusing
- 5.6 Move autofocus point
- 5.7 Resize autofocus point
- 5.8 Browsing, preview and histogram
- 6 Phocus
- 7 Settings
- 8 Accessories
- 9 Appendix
- 未标题
USING THE 907X
www.hasselblad.comCONTENTS
49
907X Special Edition USER GUIDE
Self Timer
Exposure Bracketing
Interval
●
Self Timer (A)
The camera will wait a pre-set time to make the
exposure after the Shutter release button is pressed.
Time:
Delay between shutter release and exposure.
When Finished:
Determines if the function shall be
active after a completed cycle or not. If set to
Exit
, the
Self Timer is disabled after the exposure.
●
Interval (B)
The camera will make a pre-determined number of
exposures with a pre-set interval time.
Time:
The time between exposures.
Frames:
How many exposures will be made.
Initial Delay:
Delaybetweenshutterreleaseandrst
exposure.
●
Exposure bracketing (C)
The camera will automatically make a pre-determined
number of exposures with a pre-set exposure adjust-
ment difference between each frame.
Amount:
How much exposure difference between
each exposure.
Frames:
The number of exposures in the sequence.
Initial Delay: A delay between shutter release and the
rstexposure.
Param in M:
Which of aperture or shutter speed to
change if exposure bracketing is used in manual mode.
When Finished:
Determines if the function shall be
active after a completed cycle or not.
For
Self Timer
,
Interval
and
Exposure bracketing
the left
part of the panel displays the current setting. If no changes
are required, tap the function icon again to make it active.
To change any of the parameters, tap the right part of the
screen
(D)
. This will bring up the dedicated settings for the
function. See details on the following pages.
A
B
C
D