Instruction Manual

8
SETUP & BASIC OPERATION
Essential Setup
1. Unpack the unit and remove all packaging materials.
2. Place the unit on a flat and level surface. The selected location should be stable and free from
vibration.
3.
Plug the power adaptor into the electrical outlet and connect other end to the back of the unit.
4.
Extend the FM antenna.
To Open Turntable Cover:
1.
Lift the turntable cover all the way up until it stops.
2.
Lower the cover slowly until the latch engages. If
the latch does not engage, pull the lower bar by
hand.
3.
The cover will now stay open.
To Close Turntable Cover:
1. Lift the cover all the way up until it stops.
2.
The latch should disengage and you may now slowly lower the cover. If the latch does not
disengage, push out the lower bar by hand.
3.
Make sure you hold the cover to avoid pinching your fingers as it closes.
LINE OUT
RL
DC IN
While in FM mode, tune
in an FM station and
extend the antenna to
find a position for the
best reception. This
antenna may need to
be repositioned if you
move your unit to a new
location
Power Socket
Plug the small end of the power adapter into
this socket, the other end to an AC wall socket.
Insert L pin and R pin of an
RCA cable into these two
sockets, then other end into
an outer speaker (if you
want use your speaker).