User's Manual

901 GMRS User Manual V 1.0
Date : 2003/9/19 Page 2
To change and hear a Call-Ring tone:
1. From the normal operating mode, press
[MODE]
3 times to enter the Call-Ring selection
menu. The CALL indicator will appear and the large numeric display will show the current
Call-Ring number (1 to 10).
2. Use the
[UP] or
[DOWN] buttons to change the Call-Ring tone. You can hear the Call-Ring
tone as you change your selection. There are totally 10 types of Call-Ring tones
3. The radio will return to the normal operating mode after 10 seconds or when you press the
[PTT]
button or press
[MODE]
several times back to normal operation mode.
Note : You can send Call-Ring tone only on channels 1 to 14 with
LO
power. However, you may not send Call-Ring tone
on Channel 1 to 7 with
HI
power and Channel 15 to 22 with either
HI
or
LO
power because of the
FCC’s restriction
.
To change the TX HI/LOW Power
1 From the normal operating mode, press
[MODE]
4 times to enter the HI/LOW POWER selection menu. The PO
indicator will appear Lo/HI
2 Use the
[UP] or
[DOWN] buttons to change the HI / LOW Power .
3 The radio will return to the normal operating mode after 10 seconds or when you press the
[PTT]
button or press
[MODE]
several times back to normal operation mode.
Note : You can select HI/LO power for channels 1 to 7 and channel 15 to 22. You cannot
select HI power for channels 8 to 14 because of the
FCC’s restriction
.
DW (Dual Watch)
1 From the normal operating mode, press
[MODE]
5 times to enter the Dual watch selection
menu.
2 Use the
[UP] or [DOWN]
buttons to change the main Chan
For example, if you select main channel to be 1 and dual watch channel to be 9, the radio will
monitor both channel 1 and 9 at standby. Any valid channel activities will turn on the radio’s
speaker and the radio will stay at the active channel for about 4 seconds for you to response.
If you don’t need the dual watch, set it to “OFF”.
3 The radio will return to the normal operating mode after 10 seconds or when you press the
[PTT]
button or press
[MODE]
several times back to normal operation mode.
VOX
1 From the normal operating mode, press
[MODE]
6 times to enter the VOX selection menu.
2 Use the
[UP] or [DOWN]
buttons to change the VOX sensitive level.
The most sensitive level
is level 1 and OFF means to disable the VOX function.
3 The radio will return to the normal operating mode after 10 seconds or when you press the
[PTT]
button or press
[MODE]
several times back to normal operation mode.
Note : VOX feature will be temporarily disabled during setting, receiving, transmitting, scanning
and monitoring.
To Set Roger Beep Tone
The Roger Beep is a tone which is automatically transmitted whenever the PTT button is released.
This tone alerts the receiving party that the transmission has been terminated intentionally.
To enable the Roger Beep Tone:
1. From the normal operating mode, press
[MODE]
7 times to enter the Roger Beep Setting
menu.
2. Press the
[UP]
button to select the tone on or press
[DOWN]
buttons to select the tone off
as desired.
3. The radio will return to the normal operating mode after 10 seconds or when you press the
[
PTT
] button or press
[MODE]
button back to normal operation mode.