Service manual

MAINTENANCE
2
2.3
SERVICE SPECIFICATIONS
TUNE UP
OIL CHANGE
Start the engine and warm it up for several minutes. While warming up, check for oil leaks. If any leaks are found, stop
the engine immediately and determine the source of the problem before starting the engine again.
NOTE: After the engine is started, the oil indicator light should go off. If the indicator light flickers or remains on,
immediately stop the engine and diagnose the problem before continuing.
Use Victory 20W40 Synthetic Blend 20W40 engine oil for all temperatures. If Victory oil is not available, use a high quality
20W40 motorcycle designed for use with wet clutches (such as those with a JASO MA rating).
ITEM SPECIFICATION
Specifications apply to Vegas and Kingpin models except Vegas Low where noted
Brake Pedal Freeplay (Gap at pedal stop)
Footpegs: (page 2.13): 2-5mm (.080-.200")
Floorboards: (page 2.16) 1-2mm (.040-.080")
Clutch Lever Freeplay .5 - 1.5mm (.020-.060")
Compression Pressure (Cylinder) 185-225 (1275-1551)
Drive Belt Deflection
( S e e pa g e 2 . 2 5 )
Vegas / KP
12 mm (15/32") with 10 lb force +/- 1.0 mm (+/- 1/32)
Vegas Low
6 mm (15/64") with 10 lb force +/- .5mm (+/- 1/64)
Drive Belt Frequency
(Using Sonic Tension Meter)
(See page 2.25 for required
data)
Vegas / KP
Frequency: New Belt & Sprockets = 36 Hz +/- 1 Hz
After 500 miles = 32 Hz +/- 1 Hz
Vegas Low
Frequency: New Belt & Sprockets = 50.6 Hz +/- 1 Hz
After 500 miles = 48 Hz +/- 1 Hz
Fast Idle Speed Not Adjustable (Set by PCM / IAC valve)
Fuel Type / Octane Premium Unleaded / 92 Octane Minimum (see page 5.4)
Oil Pressure, Lubrication @ 3000 rpm 552 kPa (80 psi) (Minimum 40 psi)
Oil Pressure, Cooling @ 3000 rpm (See special notes page 4.8)
Ride Height (Rear Shock Spring Pre-Load) See page 2.33
Spark Plug Type / Gap NGK DCPR6E / .8 - .9 mm (.032 - .036")
Throttle Cable Freeplay 2 - 4 mm (5/64" - 5/32")
Tire Pressure Refer to chart (page 2.9) or decal under LH side cover
TIGHTENING TORQUE
Drain Plug (Inspect / replace sealing washer) 20 Nm (15 ft. lbs. )
Oil Filter 3/4 full turn after contacting the sealing surface
OIL TYPE / QUANTITY
Oil Type Victory Semi-Synthetic 20W40 Engine Oil
Oil Capacity (Oil & Filter Change) Approximately 4.25 liters (4.5 quarts)
Oil Capacity (Dry) Approximately 4.75 liters (5.0 quarts)
NOTICE
Do not put chemical additives in the oil. Victory motorcycle oil has been specially designed for this application.
Additional additives are not necessary and have not been approved by Victory Engineering.