T 1 T U R N TA B L E V P T- 1 0 0 0
OVERVIE W Top View Tone Arm Counter Weight Back Panel Anti-Skating Knob Slipmat Tone Arm Lift Lever Tone Arm Turntable Platter Cartridge Function Knob Back View RCA Output Jacks Switchable Phono Pre-Amp Grounding Terminal Record Speed Switch AC Power Port Dust Cover Hinge
Q U I C K S TA R T G U I D E FUNCTION KNOB - BASIC OPERATION POWER ON /OFF: Turn the Function Knob to the left to turn the unit ON. Turn the Function Knob to the middle to turn the unit OFF. Note: The dial will illuminate solid white when turned ON. When the unit is OFF the dial will not be illuminated. VINYL STREAM: Turn the Function Knob to the right to connect the unit to an external Bluetooth speaker. Note: The dial will flash White when pairing to a Bluetooth speaker.
S I M P L E S E T U P GETTING STARTED Remove the needle cover, by gently pulling towards the front of the unit. Carefully plug in the unit, install platter and tone arm weight. Note: It is recommended that this product should be operated only from the type of power source indicated on the rating label. This unit uses AC power and is powered by a standard wall outlet.
T O N E A R M S E T U P ***IMPORTANT, THE TONE ARM MUST BE SET UP AS INSTRUCTED BELOW OR DAMAGE MAY OCCUR TO THE UNIT OR RECORDS. X X 0.5 0 TURN THE COUNTER WEIGHT ON THE BACK OF TONE ARM UNTIL THE TONE ARM IS FLAT AND BALANCED (SEE BOTTOM PICTURE) 2.5 0 REMOVE THE NEEDLE COVER - LIFT TONE ARM OUT OF THE HOLDER TO THE LEFT SO IT FLOATS FREELY - NOT TOUCHING ANYTHING 2 IDENTIFY THE WEIGHT ON THE BACK OF THE TONE ARM. USE THE INCLUDED 2.
V I N Y L P L AY I N G VINYL: Playing a Vinyl record Note: -Before using, make sure the tone arm is properly setup. See TONE ARM SETUP page. Using the Function Knob, turn the knob to ON. (the dial will illuminate solid white.) Remove the needle cover, by gently pulling towards the front of the unit. Select the proper record speed (see back of unit). If using a 45 RPM record, use the included 45 adaptor. Release the Tone Arm from the holder and gently place on the record using the lift lever.
CARTRIDGE REPLACEMENT CARTRIDGE: VICTROLA VPC-190 REPL ACEMENT 2MM WHITE LEFT CHANNEL + RED RIGHT CHANNEL + The VPC-190 Cartridge is rated in excess of 1000 hours of normal use. As soon as you notice a change in sound quality or damage to the stylus, it is recommended that it be changed. 1. Unplug the unit and put the needle cover on the old cartridge. 2. Carefully remove all the wire leads from the back of the old cartridge. BLACK LEFT & RIGHT CHANNEL – 3.
W A R N I N G Important Safety Instruction 1. Read these instructions – All the safety and operating instructions should be read before this product is operated. 2. Keep these instructions – The safety and operating instructions should be retained for future reference. 3. Heed all warnings – All warnings on the appliance and in the operating instructions should be adhered to. 4. Follow all instructions – All operating and use instructions should be followed. 5.
S A F E T Y I N F O Safety Information 1. In order to shut off power to this product completely, unplug the power cord from the wall outlet. Be sure to unplug the unit if you do not intend to use it for an extended period of time, such as during a vacation. 2. Use of controls, adjustments and performance of procedures other than those specified herein may result in hazardous radiation exposure. 3. To prevent electric shock, match wide blade of plug to wide slot, fully insert. 4.
entre l’antenne et votre corps. Cet émetteur ne doit pas être installé au même endroit ni utilisé avec une autre antenne ou un autre émetteur. This device complies with RSS247 of Industry Canada. Cet appareil se conforme à RSS247 de Canada d'Industrie. This device complies with Industry Canada license-exempt RSS standard(s).
Canada and US Territories The Warranty on this product shall comply with applicable law when sold to a consumer in Canada or a US Territory. To obtain any applicable warranty service, please contact the dealer from which you purchased the product, or the distributor that supplied the product, with your original receipt. If assistance from the dealer from which it was purchased is impossible, you may contact our customer service for warranty assistance at victrola.com/contact.
