Owners manual

SETTING FM RADIO PRESETS
The CD Stereo System can store up to 20 radio station presets.
To Manually Set Presets
1. Find the radio station you would like to save.
2. Press the PROGRAM button on the remote control.
3.
Press NEXT BUTTON / PREVIOUS BUTTON to select the preferred Preset
Number. The display
will show “P 01, P 02, etc...”
4. Press the PROGRAM button again to save the station.
5. Repeat steps 1-4 until you have finished saving your presets.
6. To navigate through the stored presets, press the
PREVIOUS BUTTON or
NEXT BUTTON
NOTE: If you press and hold the SCAN button, it will delete all of the previous
presets you have stored and automatically reprogram all 20 presets.
To Automatically Save Presets
Using the SCAN feature, the CD Stereo System can automatically find and save
your presets.
1. Press and hold the SCAN button. The unit will begin searching for radio staions
with clear reception.
2. Once a station is found the unit will save it as a preset. The unit will continue
searching for and save stations until all 20 presets have been filled.
3. To navigate through the stored presets, press the
PREVIOUS BUTTON or
NEXT BUTTON
NOTE: If you press and hold the SCAN button, it will delete all of the previous
presets you have stored and automatically reprogram all 20 presets.
ADJUSTING THE VOLUME
VOLUME ADJUSTMENT
Twist the VOLUME KNOB to adjust the volume. The volume level will be shown in
the LED Display in the top right corner of the unit.
NOTE: Depending on the type of music/audio output from the CD Stereo System,
the 2 Volume (VU) Meters might not move at lower volumes. In some cases, the
volume must be around “#20 or higher” to see very active movement.
BALANCE
Twist the BALANCE KNOB to adjust the volume between the left speaker and the
right speaker. The volume of the left speaker and right speaker is equal when the
LED display shows “00”.
TREBLE AND BASS
Twist the TREBLE KNOB and BASS KNOB to adjust the treble and bass levels
from “-3” to “3”.
6